High-voltage Compliant, Electrode-invariant Neural Stimulation Electronics Compatible with Low-voltage, Bulk-CMOS Integration

High-voltage Compliant, Electrode-invariant Neural Stimulation Electronics Compatible with Low-voltage, Bulk-CMOS Integration
By:Eric Philip Pepin
Published on 2015 by

This work explores the challenges of implementing practical, electrical neural stimulation interfaces using modern silicon CMOS technologies. To overcome said challenges, which stem from the discrepancy between the low-voltage limitations of modern CMOS devices and the large stimulation voltages often observed at response-evoking stimulus levels, a new stimulator front-end is proposed. The high-voltage compliant front-end can reliably drive biphasic, constant-current stimulus through a wide range of electrode impedances while being safely implemented in a low-voltage, bulk-CMOS technology. The topology of the front-end is based on a sink-regulated H-bridge. Stimulus current is supplied using specialized, fully-integrated dynamic voltage supplies (DVSs), which are controlled in closed-loop to have an output voltage approximately equal to the voltage of the electrode each supplies stimulus to. The entire stimulus waveform is regulated by a single, low-voltage current-DAC, which can safely interface with the electrodes (which may be at high voltages) via specialized high-voltage adapter (HVA) circuits. To account for |capacitive-looking| electrodes and to provide unique, |electrode-invariant| performance, the front-end uses the balancing stimulus current to discharge the electrode-tissue-interface impedance (ZE), and only after full ZE discharge has been detected is a DVS used to supply the remaining balancing stimulus. In this thesis the described front-end topology and the enabling high-voltage operating circuits are presented and discussed in detail. Additionally, a stand-alone DVS circuit has been fabricated in 65nm bulk-CMOS, demonstrating the power-supplying and transient performance required by the proposed stimulator design. Another chip, featuring the entire integrated neural stimulator front-end, has also been designed in 65nm bulk-CMOS, with post-layout simulations showing +̲11V compliance (approximately) across a 50uA to 2mA stimulus amplitude range. The efficacy of the proposed integrated electronics in potential neural stimulation applications is also explored using a board-level prototype and in-vivo evaluation.

This Book was ranked at 2 by Google Books for keyword High Voltage.

Book ID of High-voltage Compliant, Electrode-invariant Neural Stimulation Electronics Compatible with Low-voltage, Bulk-CMOS Integration's Books is UFXCjwEACAAJ, Book which was written byEric Philip Pepin

Book which was published by since 2015 have ISBNs, ISBN 13 Code is and ISBN 10 Code is

Book which have "125 Pages" is Printed at BOOK under Category

This Book was rated by Raters and have average rate at ""

eBook Version Availability Status at PDF is falseand in ePub is false

Book Preview